請教一下, 我的hs33活塞已經彈不回來了, 我有把lever拆下來清一清再上針車油, 但沒有用, 醬要怎麼修呢? 當初組車時已經換成水而不是礦物油, 有什麼方法能diy修理一下嗎? 不然又要麻煩會長, 實在很不好意思, 想說先自力救濟看看, 謝謝啦.

Quote 小漁 article-

請教一下, 我的hs33活塞已經彈不回來了, 我有把l...

you can fix it. you'll have to take the lever blade out of the lever, and pull the piston out. then you need to put some good bearing grease on the rubber o-ring.

someone translate for me please!

你操的的太兇了 ...

Quote Kevin article-

you can fix it. you'll have...

I took out the stick jointed to the lever and found the piston got completely stuck. I did some clean up and put some bearing grease trying to make it work again. Actually, it worked for like 3 minutes then it got stuck again, this time grease just wouldn't do the trick anymore...I don't see how I can pull that thing out either...

Should I use any gadget to pull it out or should I push it from the other side? In this case the whole brake needs to be disassembled...And I reckon I won't be able to assemble it again, at least not in a good way.

Quote 小漁 article-

I took out the stick jointe...

如果活塞卡死
用WD40噴完
裝上煞車把手押讓活塞先可活動

Quote jo article-

如果活塞卡死
用WD40噴完
裝上煞車把手押讓活塞先可活動

OKOK今天回去看看能不能把活賽拔出來先, 卡的很緊, 希望還有救...謝啦.

對了, 要用什麼工具拔活塞?

Quote 小漁 article-

I took out the stick jointe...

usually, it takes a bit of force to get the whole piston out. you will need to use a set of needle nose pliers to pull them out. it helps if you disconnect the lever from the main hose, so that it doesn't create a vacuum.

once you take it out, clean the inside of the lever, and get a lot of grease on the o-ring. you want a thin layer of relatively thick grease, not the liquid lube you use to penetrate.

also, the spring can be a little bit fatigued. you can pull the string out a little bit to increase the tension and your brake will feel snappy. don't do this too much, or the spring will be too strong, and it will be hard to actuate the lever.

you'll need to bleed it again after too:)

還有1個方法啦 我不敢說 怕被罵來亂的...